Development
Hardware

ST-Link V3 Developer Board



This ST-Link V3 Developer Board is designed for advanced developers who require in-circuit debugging. It is based on the ST-Link V3 Mods module and differs only in its form factor and ease of connection. Additionally, some unused ST-Link V3 Mods and Flipper Zero pins are exposed.

You don’t need this board to update your Flipper Zero
You can update the firmware, develop and upload your own firmware to Flipper Zero via USB without this Developer Board! The Developer Board is only necessary if you need to debug the firmware while it is running, using tools such as GDB, OpenOCD, and others. If you’re not familiar with how to use it, then you don’t need this board.


On this page, you’ll find the main specifications of the ST-Link V3 Developer Board, its schematics, and a link to the Altium Designer project.



Specifications

  • ST-Link V3 Mods for firmware flashing and in-circuit debug.
  • Built-in UART to USB, connected to Flipper Zero’s UART (GPIO pins 13 and 14).
  • Unused Flipper Zero pins are exposed for debugging and prototyping.


Schematic and BOM



Altium Designer project source

🤔
Have a question?
Our knowledgeable support team and an awesome community will get you an answer in a flash. Please leave your questions in English.
To ask a question or participate in discussions, you'll need to authenticate first.